Project 365: Day 60 - Spacewolf Dread WIP Part 2

If you haven;t, please make sure to check out Part 1.

Wasn't able to get a lot done on this particular model due to some unforseen developments. I was able to prime the dread as you can see below.

Here I sliced off the tape covering the holes and tabs. I also removed the tape covering the insert tabs for the weapons options. I did this to make sure that the attachment points are not too snug from that layer of primer. If i primed over the tabs, the primer will scrape off or worse yet gum and jam up the insertion point and break a tab.

Here you can see the greenstuffed fur nicely blending in with the rest of the fur. You can hardly tell it wasnt part of the model unless you were looking for it.

Arms attached and this guy is ready for drybrushing and basecoating.

Stay tuned for Part 3.